Changes to Step #7
Edit by Nick Hall —
Edit declined by Sam Goldheart
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws securing the logic board to the case: | |
| [* red] One 2.5 mm Phillips screw near the vibrator motor | |
| - | [* orange] |
| + | [* orange] screw was taken out before hand |
| [* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening. | |
| [* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff. |