Fix Your Stuff Community Store

Changes to Step #7

Edit by Jasper Fleischhauer —

Edit approved by Jasper Fleischhauer

Before
After
Unchanged

Step Lines

[* black] Remove the following screws securing the logic board to the case:
[* red] One 2.5 mm Phillips screw near the vibrator motor
[* orange] One 2.4 mm Phillips screw
[* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening.
-[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoff.
+[* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoffscrew.