Changes to Step #7
Edit by slingerfu —
Edit declined by Reed Danis
- Before
- After
- Unchanged
Step Lines
| [* black] Remove the following screws securing the logic board to the case: | |
| - | [* red] One 2.5 mm Phillips screw near the vibrator motor |
| + | [* red] One 2.5 mm Phillips screw near the [http://ow.ly/SgU8v|vibrator motor] |
| [* orange] One 2.4 mm Phillips screw | |
| [* yellow] One 3.6 mm standoff along the side of the logic board nearest the battery opening. | |
| [* icon_note] Use a small flathead screwdriver to remove the single 3.6 mm standoffscrew. |