Changes to Step #1
Edit by Oliver —
Edit declined by David Hodson
- Before
- After
- Unchanged
Step Lines
| [* icon_note] If necessary, peel the EMI gasket off the camera cable connector. | |
| [* black] Disconnect the camera cable by pulling the male end straight away from its socket toward the optical drive opening. | |
| [* icon_caution] Do not try to lift this connector straight up off the board. Pull the connector parallel to the face of the logic board. | |
| + | [* black] The connector may be fixed by a little black plastic block on the board. This block is only glued, you need to remove it, otherwise the connector must be lifted and gets easily damaged. |
| [* black] Deroute the camera data cable from the channel in the optical drive. |