Fix Your Stuff Community Store

Changes to Step #5

Edit by Kevin Horwedel —

Edit approved by Kevin Horwedel

Before
After
Unchanged

Step Lines

[* black] Use tweezers to gently flip the small locking flaps of the zero force insertion connectors up.
[* red] Pull the bottom orange connector cable out of the zero force insertion connector using the tweezers.
-[* black] Pull the top orange connector cable out of the zero force insertion connector using the tweezers.
-[* orange] Remove the ribbon cables by gently pulling them away from the no-fuss ribbon cable connectors.
+[* orange] Pull the top orange connector cable out of the zero force insertion connector using the tweezers.
+[* yellow] Remove the ribbon cables by gently pulling them away from the no-fuss ribbon cable connectors.
[* green] Remove the ribbon cables by gently pulling them away from the no-fuss ribbon cable connectors.
[* black] Disconnect the main board from the two ports on the left by pulling the main board to the right.