Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 4 guides that include this step.

Step Type:

Drag to rearrange

Bold
Italic
Underline
Link
Flip the drone on its back
Bold
Italic
Underline
Link
Remove the eight 4.5 mm hex screws by turning them counterclockwise with a 1.5 mm hex bit.
Bold
Italic
Underline
Link
Separate the mesh from the drone by pulling up gently and rocking left to right.
Bold
Italic
Underline
Link
The cable connects from the camera to the drone. Pulling up could rip the connection. Tilt the mesh 90 degrees towards the cable.

Delete Step Insert Step

« Previous

Your contributions are licensed under the open source Creative Commons license.

DJI Phantom 4 Advanced Shell Replacement

Step Type:

Guide Step Edit Keyboard Shortcuts: