iBook G4 12" 800 MHz-1.2 GHz Heat Sink Replacement

Steps Rearrange

Editing Step 5 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect the guide that includes this step.

Step Type:

Drag to rearrange

Bold
Italic
Underline
Link
The 3.5 mm Phillips screw indicated below with a red circle may be absent in some models.
Bold
Italic
Underline
Link
Remove the following 5 screws and 3 nuts from the heat sink:
Bold
Italic
Underline
Link
One 3.5 mm Phillips from the lower left corner of the heat sink.
Bold
Italic
Underline
Link
Three 6 mm Phillips from around the fan.
Bold
Italic
Underline
Link
One 7.5 mm Phillips at the top right corner of the heat sink.
Bold
Italic
Underline
Link
One 4 mm nut from the side of the heat sink.
Bold
Italic
Underline
Link
Two 4 mm screw nuts with attached springs from either side of the heat sink.

Delete Step Insert Step

« Previous

Your contributions are licensed under the open source Creative Commons license.

iBook G4 12" 800 MHz-1.2 GHz Heat Sink Replacement

Step Type:

Guide Step Edit Keyboard Shortcuts: