Apply a suction cup as close as possible to the edge of the display.

Use the suction cup to lift the edge of the display enough to insert an opening pick under the edge.

Slide the opening pick all the way around the edges of the display to cut through the adhesive on the bezel.

Do not insert the opening pick past the bezel of the display—you may permanently damage the display.

The bezel is much thinner on the bottom of the display, which is the side with the Windows logo. To avoid damage, don't poke too deep with the opening pick on the bottom edge.

Ribbon cables and a circuit board are approx. 0.6 cm from the edge of the glass.

Be very careful and move slowly during this step. The display is fragile and will crack if too much force is applied against it. If your tools seem stuck, apply more heat to further soften the adhesive.