Skip to main content
Help

Removing iPad 3 4G Front Panel

Editing Step 15 —

Notice: You are now editing a prerequisite to the guide you were just viewing. Any changes you make will affect all 153 guides that include this step.

Step Type:

Drag to rearrange

Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

Your contributions are licensed under the open source Creative Commons license.