Skip to main content

Reemplazo del panel frontal iPad 4G

Notice: You are editing a prerequisite guide. Any changes you make will affect all 153 guides that include this step.

English
Spanish

Translating step 15

Step 15
Removing iPad 3 4G Front Panel: step 0, image 1 of 3 Removing iPad 3 4G Front Panel: step 0, image 2 of 3 Removing iPad 3 4G Front Panel: step 0, image 3 of 3
  • Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

  • If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

  • Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

Continúa soltando el adhesivo a lo largo de la parte inferior del iPad, tirando de la selección de apertura lo suficiente para rodear el botón de inicio, y volver a insertarlo a una profundidad de 10 mm una vez que la púa esté pasado el botón de inicio.

Si el adhesivo se ha enfriado demasiado a lo largo del borde inferior, recalienta el iOpener para calentar el adhesivo donde está trabajando.

No calientes el iOpener más de un minuto a la vez, y siempre deja al menos dos minutos antes de recalentarlo.

Your contributions are licensed under the open source Creative Commons license.