Skip to main content

Rimozione vetro anteriore iPad 3 4G

Notice: You are editing a prerequisite guide. Any changes you make will affect all 153 guides that include this step.

English
Italian

Translating step 15

Step 15
Removing iPad 3 4G Front Panel: step 0, image 1 of 3 Removing iPad 3 4G Front Panel: step 0, image 2 of 3 Removing iPad 3 4G Front Panel: step 0, image 3 of 3
  • Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

  • If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

  • Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

Continua a separare l'adesivo sotto il bordo inferiore dell'iPad, sfilando il plettro abbastanza da aggirare il tasto Home e reinfilalo a 10 mm di profondità una volta superato il tasto Home.

Se l'adesivo si è raffreddato troppo sotto il bordo inferiore, scalda di nuovo l'iOpener per scaldare l'adesivo mentre lavori.

Non scaldare l'iOpener per più di un minuto alla volta e aspetta sempre almeno due minuti prima di riscaldarlo.

Your contributions are licensed under the open source Creative Commons license.