Skip to main content

iPad 3 4G フロントパネルの取り外し

Notice: You are editing a prerequisite guide. Any changes you make will affect all 153 guides that include this step.

English
Japanese

Translating step 15

Step 15
Removing iPad 3 4G Front Panel: step 0, image 1 of 3 Removing iPad 3 4G Front Panel: step 0, image 2 of 3 Removing iPad 3 4G Front Panel: step 0, image 3 of 3
  • Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

  • If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

  • Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

iPad下部に沿って接着剤を切開し、ホームボタンの周辺では開口ピックの大部分を引き抜いて、わずかな先端だけ差し込むようにします。ホームボタンを通過したら、10 mmの深さまで再挿入します 。

接着剤が下端に沿って冷却されている場合、再度iOpenerを準備して、接着剤を温めてください。

iOpenerを電子レンジで1分以上加熱しないでください。再度加熱する前に、必ず2分以上開けてください。

Your contributions are licensed under the open source Creative Commons license.