Fix Your Stuff Community Store

Removing iPad 3 4G Front Panel

Notice: You are editing a prerequisite guide. Any changes you make will affect all 153 guides that include this step.

Back to Guide
English
Korean
Previous step Next step

Translating step 15

Step 15
Removing iPad 3 4G Front Panel: step 0, image 1 of 3 Removing iPad 3 4G Front Panel: step 0, image 2 of 3 Removing iPad 3 4G Front Panel: step 0, image 3 of 3

  • Continue releasing the adhesive along the bottom of the iPad, pulling the opening pick out far enough to go around the home button, and re-inserting it to a depth of 1/2 inch (10 mm) once the pick is past the home button.

  • If the adhesive has cooled too much along the bottom edge, reheat the iOpener to warm the adhesive where you are working.

  • Do not heat the iOpener more than a minute at a time, and always allow at least two minutes before reheating it.

Insert translation here

Insert translation here

Insert translation here

Your contributions are licensed under the open source Creative Commons license.