Fix Your Stuff Community Store

Cambio de panel trasero de Nintendo Switch

Notice: You are editing a prerequisite guide. Any changes you make will affect all 22 guides that include this step.

Back to Guide
English
Spanish
Previous step Next step

Translating step 4

Step 4
Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: step 0, image 1 of 2 Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: step 0, image 2 of 2
Remove the top and bottom screws

  • Use a JIS 000 driver or an official iFixit PH 000 driver to remove the following screws securing the rear panel:

  • One 2.5 mm-long screw on the top edge of the device

  • Two 2.5 mm-long screws on the bottom edge of the device

  • To prevent these tight screws from stripping, apply firm downward force, work slowly and try another JIS 000 or PH 000 driver if the screws won't come out.

Retira los tornillos superiores e inferiores

Utiliza un destornillador JIS 000 o un destornillador PH000 oficial de iFixit para retirar los siguientes tornillos que fijan el panel trasero:

Un tornillo de 2.5 mm de longitud en el borde superior del aparato.

Dos tornillos de 2.5 mm de longitud en el borde inferior del aparato

Para prevenir estos tornillos duros de barrerse, aplica presión firme hacia abajo, ve despacio y trata de usar un destornillador JIS 000 o PH 000 si los tornillos no salen.

Your contributions are licensed under the open source Creative Commons license.