Fix Your Stuff Community Store

iPod Nano 4. Generation Logic Board Einheit austauschen

Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.

Back to Guide
English
German
Previous step Next step

Translating step 7

Step 7
iPod Nano 4th Generation Logic Board Assembly Replacement: step 0, image 1 of 1

  • Use a pair of tweezers to slide the click wheel ribbon cable out of its socket.

  • Before proceeding, be sure that both the click wheel ribbon cable socket and its cable are freed from the adhesive securing them to the dock connector and logic board.

  • Peel back the cable on both ends!

Schiebe das Flachbandkabel des Klickrads mit einer Pinzette aus seinem Sockel.

Bevor du fortfährst, musst du sicher sein, dass sowohl der Sockel des Flachbandkabels zum Klickrad als auch das Kabel nicht mehr am Dockanschluss und am Logic Board festkleben.

Löse das Kabel an beiden Enden ab!

-[* black] Use a pair of tweezers to slide the click wheel ribbon cable out of its socket.
+[* black] Use a pair of [product|IF145-020|tweezers] to slide the click wheel ribbon cable out of its socket.
[* icon_caution] Before proceeding, be sure that ***both*** the ***click wheel ribbon cable socket*** ''and'' ***its cable*** are freed from the adhesive securing them to the dock connector and logic board.
[* black] Peel back the cable on both ends!

Your contributions are licensed under the open source Creative Commons license.