Skip to main content

Reemplazo de la placa de escudo de LCD de iPad Mini 3 Wi-Fi LCD

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.

English
Spanish

Translating step 21

Step 21
iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: step 0, image 1 of 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: step 0, image 2 of 3 iPad Mini 3 Wi-Fi LCD Shield Plate Replacement: step 0, image 3 of 3
  • Leave the pick from the last step in place to prevent the adhesive from re-sealing.

  • With a new pick, slice gently over the left-hand antenna, stopping before the home button.

  • Only slide the pick from the outer edge toward the center of the iPad. Do not move the pick back toward the outer edge, as moving in this direction may damage the antenna.

  • If you need to slide the pick over the lower section more than once, remove it and re-insert at the outer edge, and slide inwards.

  • Leave the pick in place before moving on.

Deja en su sitio la púa del último paso para evitar que se vuelva a sellar el adhesivo.

Con una púa nueva, deslízala suavemente sobre la antena izquierda, deteniéndote antes del botón de inicio.

Desliza la púa sólo desde el borde exterior hacia el centro del iPad. No desplaces la púa hacia el borde exterior, ya que el movimiento en esta dirección puede dañar la antena.

Si necesitas deslizar la púa por la parte inferior más de una vez, retírala y vuelve a introducirla por el borde exterior, y deslízala hacia dentro.

Deja la púa en su sitio antes de continuar.

Your contributions are licensed under the open source Creative Commons license.