Fix Your Stuff Community Store

Eliminación de la Touchbar del MacBook Pro de 13" con dos puertos Thunderbolt 2020

Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.

Back to Guide
English
Spanish
Previous step Next step

Translating step 34

Step 34
MacBook Pro 13" Two Thunderbolt Ports 2020 Touchbar Removal, Removing Logic Board Screws: step 0, image 1 of 2 MacBook Pro 13" Two Thunderbolt Ports 2020 Touchbar Removal, Removing Logic Board Screws: step 0, image 2 of 2
Removing Logic Board Screws

  • Locate and remove 5x Logic Board Screws

  • 3x 3.4mm Torx T5 screws

  • 1x 3.6mm Torx T5 stepped screw

  • 1x 3.3mm hex standoff (3mm drive)

  • During Reassembly: It may be difficult to screw the top left logic board standoff back in. If you are finding it hard to do this, take the 1.4mm screw that we removed to remove the power button bracket and screw it into the top left logic board standoff. Afterwards, take the now "cyborg" screw and screw it into the logic board.

  • Don't forget to remove the 1.4mm screw from the logic board standoff during reassembly

Quitar los tornillos de la placa lógica

Ubica y retira 5 tornillos de la placa lógica

3 tornillos Torx T5 de 3,4 mm

1 tornillo escalonado Torx T5 de 3,6 mm.

1 separador hexagonal de 3,3 mm (unidad de 3 mm)

Durante el reensamblaje: puede resultar difícil volver a atornillar el separador de la placa lógica superior izquierda. Si te resulta difícil hacerlo, toma el tornillo de 1,4 mm que retiramos para quitar el soporte del botón de encendido y atorníllalo al tablero de la lógica superior izquierda.

Luego, toma el tornillo ahora "cyborg" y atorníllalo en la placa lógica.

No olvides quitar el tornillo de 1,4 mm del separador de la placa lógica durante el reensamblaje.

Your contributions are licensed under the open source Creative Commons license.