Skip to main content

Procedura di apertura e disconnessione della batteria

Notice: You are editing a prerequisite guide. Any changes you make will affect all 17 guides that include this step.

English
Italian

Translating step 10

Step 10
Opening Procedure and Battery Disconnect: step 0, image 1 of 3 Opening Procedure and Battery Disconnect: step 0, image 2 of 3 Opening Procedure and Battery Disconnect: step 0, image 3 of 3
  • Insert a new opening pick into the bottom left corner and slide it around the corner toward the left edge.

  • Be careful cutting under the lower 2.5 inches (65 mm) of the left edge. Do not insert the opening pick more than 1/8 inch (3 mm) here. The display cables sit near this part of the bezel and are easily damaged. Once past the display cable area, do not insert the pick past the bezel.

  • Slide the pick along the left edge of the Surface to cut through the screen adhesive.

  • Leave this pick in the left edge to prevent the adhesive from resealing.

Infila un altro plettro sotto l'angolo in basso a sinistra e fallo scorrere attorno all'angolo, verso il bordo sinistro.

Stai attento nel tagliare sotto i 6,5 cm inferiori del bordo sinistro. Non infilare il plettro per più di 3 mm qui. I cavi dello schermo sono vicini a questa parte della cornice e si possono danneggiare facilmente.

Fai scorrere il plettro sotto il bordo sinistro del Surface per tagliare l'adesivo dello schermo.

Lascia questo plettro infilato sotto il bordo sinistro per evitare che l'adesivo si reincolli.

Your contributions are licensed under the open source Creative Commons license.