Skip to main content

開口方法とバッテリー接続の外し方

Notice: You are editing a prerequisite guide. Any changes you make will affect all 17 guides that include this step.

English
Japanese

Translating step 10

Step 10
Opening Procedure and Battery Disconnect: step 0, image 1 of 3 Opening Procedure and Battery Disconnect: step 0, image 2 of 3 Opening Procedure and Battery Disconnect: step 0, image 3 of 3
  • Insert a new opening pick into the bottom left corner and slide it around the corner toward the left edge.

  • Be careful cutting under the lower 2.5 inches (65 mm) of the left edge. Do not insert the opening pick more than 1/8 inch (3 mm) here. The display cables sit near this part of the bezel and are easily damaged. Once past the display cable area, do not insert the pick past the bezel.

  • Slide the pick along the left edge of the Surface to cut through the screen adhesive.

  • Leave this pick in the left edge to prevent the adhesive from resealing.

新しいオープニングピックを左下隅に挿入し、コーナーの周りを通して、左端に向かってスライドします。

左端の下65 mmの下を切開するように注意してください。オープニングピックを3 mm以上挿入しないでください。ディスプレイケーブルはベゼルのこの部分の近くにあり、簡単に損傷します。ディスプレイケーブル領域を通過したら、ベゼルを超えてピックを挿入しないでください。

ピックをSurface本体左端に沿ってスライドさせて、スクリーン接着剤を切り取ります。

接着剤が再装着するのを防ぐために、このピックを左端に残します。

Your contributions are licensed under the open source Creative Commons license.