Skip to main content

iPad 7 LCDの交換

Notice: You are editing a prerequisite guide. Any changes you make will affect all 15 guides that include this step.

English
Japanese

Translating step 5

Step 5
iPad 7 LCD Replacement, Disconnect the battery: step 0, image 1 of 3 iPad 7 LCD Replacement, Disconnect the battery: step 0, image 2 of 3 iPad 7 LCD Replacement, Disconnect the battery: step 0, image 3 of 3
Disconnect the battery
  • Be careful when you isolate the battery using a battery blocker. The battery contacts are easily bent or broken, resulting in irreversible damage.

  • Ensure that the iFixit logo on the battery blocker is facing up.

  • Slide the battery blocker underneath the logic board's battery connector at a 35 degree angle.

  • Don't push the battery blocker underneath the connector with excessive force. If you're having trouble fitting the battery blocker underneath the logic board, you can try using a playing card to disconnect the battery instead.

  • The battery blocker or playing card ideally should slide under the logic board without encountering any blockages. After insertion, it should rest at about a 15 degree angle.

  • Leave the battery blocker in place as you work.

バッテリー・ブロッカーを使用してバッテリーを分離する際は注意してください。バッテリーの接点は簡単に曲がったり折れたりするため、取り返しのつかない損傷につながります。

バッテリーブロッカーのiFixitロゴが上を向いていることを確認します。

バッテリーブロッカーをロジックボードのバッテリーコネクターの下へ35度の角度でスライドさせます。

バッテリーブロッカーをコネクタの下に強い力で押し込まないでください。バッテリーブロッカーをロジックボードの下に入れるのが難しい場合は、代わりにトランプを使ってバッテリーの接続を外してみてください。

バッテリーブロッカーやトランプは、ロジック・ボードの下を何の障害もなくスムーズに滑り込むのが理想的です。挿入した後、約15度の角度で静止させます。

作業中はバッテリーブロッカーをそのままに残しておきます。

Your contributions are licensed under the open source Creative Commons license.