Skip to main content

MacBook Pro 13" Touch Bar 2018 로직보드 교체

Notice: You are editing a prerequisite guide. Any changes you make will affect all 7 guides that include this step.

English
Korean

Translating step 2

Step 2
MacBook Pro 13" Touch Bar 2018 Logic board Replacement, Remove the pentalobe screws: step 0, image 1 of 1
Remove the pentalobe screws
  • Before proceeding, unplug and power down your MacBook. Close the display and lay it on a soft surface, top-side down.

  • Use a P5 Pentalobe driver to remove the six screws securing the lower case:

  • Two 6.2 mm screws

  • Four 3.4 mm screws

  • Throughout this repair, keep track of each screw and make sure it goes back exactly where it came from to avoid damaging your device.

계속하기 전에 MacBook의 플러그를 뽑고 전원을 끄세요. 디스플레이를 닫고 부드러운 표면에 윗면이 아래로 향하도록 놓으세요.

P5 펜타로브 드라이버를 사용하여 하단 케이스를 고정하는 나사 6개를 풀어주세요:

6.2 mm 나사 두 개

3.4 mm 나사 네 개

수리하는 동안 각 나사를 추적하고 기기 손상을 방지하기 위해 나사가 원래 있던 위치로 정확히 돌아가는지 확인하세요.

Your contributions are licensed under the open source Creative Commons license.