Notice: You are editing a prerequisite guide. Any changes you make will affect all 3 guides that include this step.
When reassembling your device, attach the gasket to the heat sink as shown.
The tail of the gasket should fit into the notch in the heat sink, it should not end up underneath the heat sink tab that will rest on the logic board.
Be sure the small post molded into the rubber gasket mates with the hole cut into the upper right corner of the logic board.
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.
Open help
