Skip to main content

Sostituzione Gruppo Pannello Frontale iPhone 5s

Notice: You are editing a prerequisite guide. Any changes you make will affect all 32 guides that include this step.

English
Italian

Translating step 17

Step 17
iPhone 5s Front Panel Assembly Replacement: step 0, image 1 of 1
  • Remove the following screws securing the front panel assembly cable bracket to the logic board:

  • One 1.7 mm Phillips #000 screw

  • One 1.2 mm Phillips #000 screw

  • One 1.3 mm Phillips #000 screw

  • One more 1.7 mm Phillips #000 screw

  • This 1.7 mm screw tends to not be attracted to a magnetized screwdriver. Take care not to lose it when removing.

  • It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 1.3 mm screw or one of the 1.7 mm screws in the bottom right hole will result in significant damage to the logic board causing the phone to no longer boot properly.

  • Be careful not to over-tighten the screws, and don't force them. If they don't fit easily when you are securing them, they may be the wrong size.

Rimuovi le seguenti viti che fissano il cavo del gruppo del pannello frontale alla scheda logica.

Una vite a croce Phillips #000 da 1,7 mm

Una vite a croce Phillips #000 da 1,2 mm

Una vite a croce Phillips #000 da 1,3 mm

Un'altra vite a croce Phillips #000 da 1,7 mm

Questa ultima vite da 1,7 mm tende a non farsi attrarre da cacciaviti magnetici. Fai attenzione a non perderla durante la rimozione.

È particolarmente importante tenere nota della posizione delle viti per il successivo rimontaggio. Usare erroneamente la vite da 1,3 mm oppure una di quelle da 1,7 mm nel foro inferiore destro potrebbe danneggiare seriamente la scheda logica e impedire quindi al telefono di avviarsi correttamente.

Attenti a non serrare troppo forte le viti. Se non entrano facilmente mentre le stai avvitando, potrebbero essere della misura sbagliata, quindi non forzarle.

Your contributions are licensed under the open source Creative Commons license.