Fix Your Stuff Community Store

iPhone 4 Verizon 版本电池更换

Notice: You are editing a prerequisite guide. Any changes you make will affect all 16 guides that include this step.

Back to Guide
English
Chinese
Previous step

Translating step 3

Step 3
iPhone 4 Verizon Battery Replacement: step 0, image 1 of 2 iPhone 4 Verizon Battery Replacement: step 0, image 2 of 2

  • Pull up on the exposed clear plastic tab to peel the battery off the adhesive securing it to the iPhone.

  • If the tab breaks before the battery is freed, apply a few drops of high concentration (over 90%) isopropyl alcohol under the edge of the battery. Wait about one minute for the alcohol solution to weaken the adhesive. Carefully slide a spudger under the battery tab to release the adhesive.

  • Prying in other places may cause damage. Don't try to forcefully lever the battery out. If needed, apply a few more drops of alcohol to further weaken the adhesive. Never deform or puncture the battery with your pry tool.

  • If there's any alcohol solution remaining in the phone, carefully wipe it off or allow it to air dry before installing your new battery.

  • Remove the battery.

  • If your replacement battery came in a plastic sleeve, remove it before installation by pulling it away from the the ribbon cable.

  • Before reassembly, clean metal-to-metal contact points with a de-greaser such as windex. The oils from your fingers have the potential to cause wireless interference issues.

  • Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting.

用塑料拉手轻轻将电池从机身中拉出。

如果在电池拉出前塑料拉手坏了，沿着塑料拉手方向小心的用手机撬棒在电池背部滑动几下除去胶条。在别的部位可能会造成损坏。

如果你的更换电池采用塑料套管，请在安装前将其从带状电缆中拉出来将其取下。

在扣电池座以前，确保排线接口与电池座位置相符。

在重新安装电池之前，先对金属接口机油进行处理比如清洁剂。手指上的油脂是潜在的危险对于无线链接模块。

进行强制重启在安装完成后，可以有效的避免一些错乱的状况。

Your contributions are licensed under the open source Creative Commons license.