Notice: You are editing a prerequisite guide. Any changes you make will affect all 14 guides that include this step.
Translating step 11
Step 11
Remove the logic board screws
-
Remove the following 8 screws:
-
Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
-
Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
-
One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
-
Note for re-assembly:
-
The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
| + | [title] Remove the logic board screws |
|---|---|
| [* black] Remove the following 8 screws: | |
| [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case. | |
| [* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera. | |
| [* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker. | |
| [* black] Note for re-assembly: | |
| [* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place. | |
| [* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera |
Your contributions are licensed under the open source Creative Commons license.