Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.
Translating step 2
Step 2
-
Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards.
-
Use the spudger to remove the connector on the left side.
-
Remove the 2.4 mm Phillips screw.
-
Remove the 1.6 mm Philips screw.
| [* black] Use a spudger (or your fingernails) to remove the gold antenna. The antenna bends easily, so make sure not to apply too much pressure. When re-assembling, put the gold antenna in place before inserting the antenna circuit boards. | |
| [* black] Use the spudger to remove the connector on the left side. | |
| - | [* red] Remove two Phillips screws. |
| + | [* red] Remove the 2.4 mm Phillips screw. |
| + | [* yellow] Remove the 1.6 mm Philips screw. |
Your contributions are licensed under the open source Creative Commons license.