Fix Your Stuff Community Store

MacBook Air 13" Mid 2011 I/O Board Replacement

Notice: You are editing a prerequisite guide. Any changes you make will affect all 5 guides that include this step.

Back to Guide
English
German
Previous step Next step

Translating step 2

Step 2
MacBook Air 13" Mid 2011 I/O Board Replacement: step 0, image 1 of 1

  • Pull the camera cable parallel to the face of the I/O board toward the corner of the Air to disconnect it from its socket, using the tip of a spudger to help push the connector out of its socket.

  • Do not lift upward on this cable as you disconnect it, as its socket may break off the logic board.

Ziehe das Kamerakabel parallel zu der Vorderseite der I/O Blende in Richtung der Ecke des Airs, um es von seiner Fassung zu trennen. Mit der Spudgerspitze kannst du nachhelfen, um den Stecker aus seiner Fassung zu bekommen.

Ziehe dieses Kabel nicht nach oben, während du es trennst, da sonst die Fassung aus dem Logic Board herausbrechen kann.

Your contributions are licensed under the open source Creative Commons license.