Pending Edits to MacBook Pro 15" Touch Bar Late 2016 Trackpad Assembly Replacement
Note: Accepting or denying any edit implicitly applies to all earlier pending edits to the same step or introduction.
Step edited: [Step created]
Edited by Lei F (1)
(You don't have enough reputation to patrol this edit.)
| + | [* icon_caution] ***DO NOT FLIP THE TRACKPAD! *** There are tiny washers that may fall off and get lost. ***SEE THE NEXT STEP BEFORE REMOVING THE TRACKPAD!*** |
|---|
Step #6 edited: [Step edited]
Edited by Lei F (1)
(You don't have enough reputation to patrol this edit.)
| [* black] Swing the display open slightly, but keep the MacBook upside-down. The trackpad assembly should separate and lay flat on the display. | |
| [* black] Gently feed the trackpad's ribbon cable through its slot in the chassis. | |
| [* icon_reminder] Carefully note the correct slot for the trackpad cable during reassembly—it goes through the narrow slot alongside the battery, not the bigger slot near the MacBook Pro's front edge. | |
| + | [* icon_caution] ***DO NOT FLIP THE TRACKPAP!*** There are tiny washers that may fall off and get lost. ***SEE THE NEXT STEP BEFORE REMOVE TRACKPAD! *** |
Introduction edited
Edited by Lei F (1)
(You don't have enough reputation to patrol this edit.)
Steps
Step #: 1
Before
After
Step #: 2
Before
After
Step #: 3
Before
After
Step #: 4
Before
After
Step #: 5
Before
After
Step #: 6
Before
After
Step #: 7
Before
After
Step #: 8
Before
After