JBL Flip 2 A standard charging port replacement went south when the centre screw removed this component from the main...

Hi Guys, I've been tasked with repairing this Water Damaged Xperia Z3 Compact which has lost its display. There is visible...

Hi Guys, Hope you can help.. Shortly before Christmas I was tasked with refurbishing an iPhone 5s for a client. On...

Hi Guys, this is the second time this has happened to me, I changed the charging port on a Galaxy s3 i9300 which went...

Hi Guys, Could you please have a look at the following picture and let me know the values of the components shown in red.....

When the battery Dies the phone loses it's date and time settings, reverting back to 1970. Does the iphone have a seperate...

Just for any one finding this post.. In the cases I have experienced this is a hardware fault.. I've had it a few times with Galaxy S5's and replacing the LCD has fixed the problem every time..

Well guys.. It wasn't the ic chip.. After replacing the mic a third time I still had no sound, but if you blew across the mic it you could hear the wind, but still wouldn't pick up sound from voice which me think the it was a faulty mic, so I replaced it a fourth time ensuring that the board was at the melting point of the solder just before placing the mic, and a very quick blast of heat fixed the mic in place.. and this time it worked!! So turns out that the mic's are very sensitive to too much heat and possibly flux as well.. Thanks for you advise guys, much appreciated

Hi Guys, I have a similar issue, if not the same. Unplugged the Battery, then disconnected the screen connectors carefully with a plastic spludger.. and connected the bare new screen to see if it worked before doing the repair, Nothing.. no back-light or any signs of life, so reconnected the old screen with the same issue :( iTunes does recognize the phone when its plugged in, but my PC is not authorized for this phone.. when the phone is on charge it draws power, but just pings every 5 seconds.. All connectors are clean with good connection, there were no screws in the connector plate after removing them, and the phone was working fine prior to removing them.. Sorry this is not a solution Miki.. would have loved to read one here.. :(