A 0.2 ohm short across these 2 points

I solved this , there was a burned resistor on the upper board , see the no voltage at the pin note in above photo,

Update , I guess the 10.5 vdc is correct , (it seemed low compared to other amps i have worked on) , I found a bad joint on resistor 103 and a 100 uf cap (C203) was bad too (see pics) . It is working fine again now .. https://www.dropbox.com/s/c7yzm5nup8fjwr...-12-2019%2C%209%2038%2025%20am.jpg?dl=0 https://www.dropbox.com/s/pic4y3h2dobso0...-12-2019%2C%209%2050%2006%20am.jpg?dl=0

Did you find an adhesive suitable for the home button bracket , or is super glue the answer ? , i'm having the same issue on an ipad mini 4

thanks for your help , just to be certain , this is correct ? .

Hi ,sorry for the delay on answering , i Finally! , found some time to spend on this board , , yes thats correct the phone booted up fine and charged . I tunes does not see it when plugged in . I put the shields back on by just touching the solder points with the iron tip , i thought maybe i pressed down a bit hard to get the solder points to line up (breaking the U1600). I had a good look around the board for dislodged components as you suggested and found R78 was dislodged so i put that back on and was kind of hopeful but still same fault , i checked the voltage on PP_BATT_VCC : These are all the components on that line , do i need to test voltage at all the components on a line to check a line ? . L4 3.8V C332 3.8V C333 3.8V C337 3.8V C3337 3.8V C335 3.8V C48_RF 3.8V C42_RF 3.8V C44_RF 3.8V C43_RF 3.8V C45_RF 3.8V C51_RF 3.8V C47_RF 3.8V C46_RF 3.8V C49_RF 3.8V C1214_RF 3.8V C100_RF 3.8V C1201_RF 3.8V C229_RF 3.8V R32_RF 3.8V C184_RF 3.8V C118_RF 3.8V C148_RF 3.8V C242_RF 3.8V C154_RF 3.8V L5 3.8V C387...

this was a fault with the logic board .

Thanks for the replies guys , ive done the smc reset , also the efi and smc firmware appears to be correct versions , What kind of battery is inside the blue plastic of the PRAM battery can one be soldered in as i can only find a used one on ebay ,. I cant believe the local apple repair center class this as "vintage" and won't repair it !! . I will have a look at the LVDS connecter tonight when there are less little inquisitive fingers around !! , I have a usb microscope somewhere i will try and dig it out and have a good look . I presume its a case of changing different parts until i find the culprit ? It did have a new mainboard under the invidia chip problem , in 2011 i think it was .. thanks for your help ..