Rep: 1
1
Hi . I tried replacing my left analog with a new one due a drift issue, but now it's stuck on pointing up . Tried to put the old one back and same issue. Is there anything to do to try save it or it need a new board now ? Thank you
Is this a good question?
Rep: 16k
20
12
20
Hi!
So the old one has the same issue now? Then most likely a solder pad/trace is damaged. Please make some photo's of the board and share it with us. With this we can determine what need to be done. Thanks!
Was this answer helpful?
Also , i know the potentiometer is not there , i tired without one and it still points up . The left/right works fine
@hamodizoabi Would you happen to have pictures of the board to ensure the traces within it aren't damaged?
I tried, not sure if you can actually see anything.
Would it be possible that I over heated the board ?
Overheating the board is possible. Because other components can be damaged with too much heat. Best thing to do is to post a picture (if possible). If a pad broke or trace, we should be able to see it. Thanks!
@dan0 i updated the pictures, is this board what you asking for or im missing something?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 6
All Time: 49
1 Comment
Sorry for the late reply i didn't have time to take pictures.
Here is some pics , and yes i took the potentiometer off and it still pointing up
by Hamodi zoabi