Fix Your Stuff Community Store

更换任天堂Switch背部外壳

Notice: You are editing a prerequisite guide. Any changes you make will affect all 22 guides that include this step.

Back to Guide
English
Chinese
Previous step Next step

Translating step 4

Step 4
Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: step 0, image 1 of 2 Nintendo Switch Rear Panel Replacement, Remove the top and bottom screws: step 0, image 2 of 2
Remove the top and bottom screws

  • Use a JIS 000 driver or an official iFixit PH 000 driver to remove the following screws securing the rear panel:

  • One 2.5 mm-long screw on the top edge of the device

  • Two 2.5 mm-long screws on the bottom edge of the device

  • To prevent these tight screws from stripping, apply firm downward force, work slowly and try another JIS 000 or PH 000 driver if the screws won't come out.

移除顶部和底部螺丝

使用 JIS000 螺丝刀，或者 iFixIt PH000 螺丝刀取下用于固定后面板的螺丝：

一颗在主机顶部的散热器出口旁，长度为2.5毫米的螺丝

两颗在主机底部的充电接口两侧，长度为2.5毫米的螺丝

面板上的这些螺丝比较容易滑丝，为了防止滑丝发生，在拆卸过程中请用力向螺丝施加压力，同时缓慢拧动螺丝刀，如果螺丝无法拧出来，尝试换另一个JIS 000 或 PH 000 螺丝刀试一下。

Your contributions are licensed under the open source Creative Commons license.