Notice: You are editing a prerequisite guide. Any changes you make will affect the guide that includes this step.
Translating step 2
Step 2
Remove yellow cables
-
Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place.
-
Use the tweezers to pull the flat, yellow cable out of its connectors.
-
Use the tweezers to disconnect the battery connector from the circuit board.
-
Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable.
-
Remove the flat, orange cable.
[title] Remove yellow cables | |
[* red] Use a spudger tool to release the black clips on the two connectors holding the flat, yellow cable in place. | |
- | [* black] Use the tweezers to pull the flat, yellow cable out of its connectors. |
+ | [* black] Use the [product|IF145-020|tweezers] to pull the flat, yellow cable out of its connectors. |
[* orange] Use the tweezers to disconnect the battery connector from the circuit board. | |
[* yellow] Using the spudger tool again, pry up and release the connectors at the ends of the flat, orange cable. | |
[* black] Remove the flat, orange cable. |
Your contributions are licensed under the open source Creative Commons license.