Notice: You are editing a prerequisite guide. Any changes you make will affect all 4 guides that include this step.
Translating step 1
Step 1
-
Remove the 2 screws (3.2mm, Phillips #00) found on the bottom side of the camera.
-
Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera.
-
Remove the 2 screws (3.2mm, Phillips #00) found on the side of the camera where the terminals are.
-
Open the flap revealing the cable inputs and remove the final screw (3.8mm, Phillips #00) found inside.
Your contributions are licensed under the open source Creative Commons license.