Fix Your Stuff Community Store

Remplacement de la batterie de l'iPhone 3G

Notice: You are editing a prerequisite guide. Any changes you make will affect all 14 guides that include this step.

Back to Guide
English
French
Previous step Next step

Translating step 11

Step 11
iPhone 3G Battery Replacement, Remove the logic board screws: step 0, image 1 of 1
Remove the logic board screws

  • Remove the following 8 screws:

  • Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.

  • Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.

  • One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.

  • Note for re-assembly:

  • The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.

  • Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

Insert translation here

Retirez les 8 vis suivantes:

Cinq vis cruciformes #00 de 2,3 mm à filetage partiel, qui attachent la carte mère au boîtier arrière.

Deux vis cruciformes #00 de 2,3 mm à filetage total, qui maintiennent la carte mère et la caméra.

Une vis cruciforme #00 de 2,9 mm sous le sticker "Do not remove".

Remarque pour le remontage:

La vis qui est placée près de la camera (en bas à droite en orange) dispose aussi d'une bande métallique qui maintient la caméra en place.

N'oubliez pas de remettre cette bande avant de réinsérer la vis cruciforme #00 de 2,3 mm à filetage total près de la caméra.

+[title] Remove the logic board screws
[* black] Remove the following 8 screws:
[* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear case.
[* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
[* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
- [* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera
+ [* icon_reminder] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screw with full thread next to the camera

Your contributions are licensed under the open source Creative Commons license.